Single blade labyrinth type drip tape

Keywords:

Drip Irrigation System Product

Single blade labyrinth type drip tape production line

Category:

Enquiry hotline:

+8613656349999

E-mail:

ken.chen@huaweidrip.com

whatsapp:

8619863482608

Product details

I. Performance characteristics

1、The labyrinth runner and drip hole are moulded by vacuum integral hot pressing, good adhesion and high manufacturing precision.

2、Turbulent flow state with multiple outlets, strong anti-clogging ability.

3, labyrinth runner design, water uniformity, up to 85% or more, laying up to 80m.

4、Light weight, easy to install and manage, low cost of manual installation.

Second: the use of precautions

1. Protection requirements: handling can not be thrown, rolling, barbaric loading and unloading is strictly prohibited to avoid wear and tear and hard objects hurt drip irrigation belt.

2. Stacking site should be flat, the product should be stored with attention to protection, labelling to the outside, easy to identify, and shall not be exposed to the sun.

3. Stacking site should be anti-rodent measures to avoid drip irrigation belt by rats and other things to gnaw.

4. Soil requirements: the use of products, according to different soil characteristics need to choose to use different specifications of the drip irrigation belt, specifications should be based on engineering design drawings.

5. Seeder requirements: Before laying this product, please carefully check the seeder, especially the guide ring, pressure belt wheel, positioning wheel, must be flexible, smooth, no burrs, welding slag and other sharp objects damage to the drip pipe belt. Drip tape should be placed flat on the ground to prevent external forces such as pulling, grinding, scratching and other damage to the drip irrigation tape.

Third: laying requirements

1. When laying, single-wing labyrinth drip irrigation belt labyrinth runner convex surface must be up, is strictly prohibited reverse laying. Inset patch drip irrigation belt patch face up.

2. Paving drip irrigation belt should not be pulled too tight, should leave a certain amount of shrinkage.

3. Laying at the same time, should carefully check the drip irrigation belt laying quality, pay attention to whether there is no scratching, abrasion and other damage to the drip irrigation belt phenomenon.

4. Laying the ground should be flat, to prevent the soil, weeds, trenching and laying caused by the membrane and the drip tape to produce a certain distance, so that the vapour dripping in the membrane, the formation of the lens effect, drip irrigation belt. In order to prevent burns and crows and magpies pecking drip irrigation belt, should be covered with 3.5cm of soft soil on the drip irrigation belt after laying.

In order to prevent burns and crows and magpies pecking the drip irrigation belt, the drip irrigation belt should be covered with 3.5cm soft soil after laying.

Fourth, the use of requirements

1. The water into the drip irrigation belt must be filtered to prevent sand, soil and other foreign matter into the drip tube belt, blocking the flow to.

2. After each drip, the end of the drip irrigation belt open for flushing.

3. Drip irrigation belt use, should be slow exhaust, to prevent local holding pressure, resulting in local pressure over the working pressure, so that the drip irrigation belt caused by damage.

Drip Irrigation system

none

Drip Irrigation system

none

Send Inquiry